Hello All,
I have build up a flexible tube with points and curve (spline).
These tube I add to my assembly.
The end- and start-Point of the tube is guided by flexibility so that the end- and start-point
fits to my connection-point in my assemly.
But now I want to edit the curve-points between end- and start-point.
I have to do this in the assembly, because I want see where is collison,
bewtween the tubes, between other parts.
An dynamic editing is in assemblies not possible
It is only the tube-part possible (see white square at the measurement)
Why not ??
Regards
Matthias