Clik here to view.
Crack Width Calculations
Though the latest ACI 318 code controls crack issues with spacing requirements instead of calculating crack width, it may be still important for water-containing structures.The attached are references...
View ArticleWhat's the difference between a document, blog, and a discussion?
Documents, blogs, and discussions were born and raised on the Web, so you use them in the PTC Community as you would there. The following table suggests ways to think about the different content types....
View ArticleClik here to view.
New York - San Francisco Tunnel (движение по подземному прямому тоннелю...
A train leaves New York at 9:45am EDT, heading for San Francisco...The train system consists of a straight-line tunnel connecting the two cities. The train uses a MAGLEV (magnetic levitation) system...
View ArticleClik here to view.
Mathcad 15 M045 release notes ("Read This First" guide)
PDF file "Mathcad 15.0 M45 Read This First" can be found in attachment to this document.
View ArticleClik here to view.
Windchill Quality Solutions 11.0 F000 release notes
PDF file "PTC Windchill Quality Solutions 11.0 Release Notes" can be found in attachment to this document.
View ArticleClik here to view.
Статья о факультативе
Статья о факультативе в журнале "Информатика в школе", №10, 2015 г. - см. аттач.
View ArticleClik here to view.
Clik here to view.
What are your favorite features that are new to Creo 1, 2, and Creo 3 (and...
Valuable bantering aside for the moment ;-) , there are some great improvements in Creo and I am curious at compiling these into one document! What I have found is that it takes a lot of time for...
View ArticleRelease Notes: PTC University Expert Model Analysis 2.4 (XMA)
PTC University Expert Model Analysis 2.4 was released on December 15, 2015. This is a small release that allows PTC University to enable, disable or limit features in XMA Desktop via the license file...
View ArticleList (and discussion) of features removed when going from ProE (WF1-WF4) to...
When preparing to go from ProE WF4 to Creo 3 a PTC rep said that there were hundreds (I think he said over 400) enhancements going from WF4 to Creo 2 'while no features have been removed'...
View ArticleClik here to view.